KIA RIO

since 2000 of release

Repair and car operation


Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
- 10. Suspension bracket
   10.1. Specifications
   10.2. Check of elements of a forward suspension bracket
   10.3. Check and adjustment of corners of installation of wheels
   10.4. Convergence of forward wheels
   10.5. Rack of a forward suspension bracket
   10.6. Bottom lever of a forward suspension bracket
   10.7. Forward stabilizer of cross-section stability
   10.8. Beam of a back suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment

10.4. Convergence of forward wheels

 Check

PERFORMANCE ORDER
1. Lift a forward part of the car so that forward wheels slightly rose over the earth.
2. Manually turn wheels and carry out lines on the center of tires.
3. Establish forward wheels for movement directly forward and lower the car.
4. Measure distance between the carried-out lines from the forward and back parties of wheels. Both distances should be measured at identical distance from the earth. The distance between wheels in a back part should be more than in a forward part on 4±3 mm.

Adjustment

If the convergence does not correspond to demanded value, weaken the left and right lock-nuts of tips of steering drafts, then rotating drafts establish demanded corners. Tighten lock-nuts.

Prevention

The left and right tips of steering drafts have the right carving. For reduction the convergence is necessary to rotate the right and left steering drafts, turning out them from tips of steering drafts and on the contrary.

One complete turn of both connecting drafts changes a positive convergence approximately to 6 mm. Can be it is necessary to rotate one steering draft more than another to reach a demanded corner of a convergence, at preservation of installation of provision of a steering wheel.

PERFORMANCE ORDER
Tighten lock-nuts of tips of steering drafts.

Inhaling moment: 34–50 N • m