KIA RIO

since 2000 of release

Repair and car operation



Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
- 4. Cooling system
   4.1. Specifications
   4.2. Cooling liquid
   4.3. Replacement of cooling liquid
   4.4. Water pump
   4.5. Radiator
   4.6. Check of tightness of system of cooling
   4.7. Engine of the fan of a radiator
   4.8. Check of a cover of a radiator
   4.9. Valve of return pressure
   4.10. Thermostat
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment


4.4. Water pump

GENERAL INFORMATION

Sequence of removal of the water pump, thermostat and pipes of system of cooling

1–entrance pipe of system of cooling and laying;
2–bypass pipe and sealing ring of round section;
3–water pump;
4–laying of the water pump;
5–thermostat

Removal

PERFORMANCE ORDER

Prevention

The water pump is not maintainable and in case of an exit it out of operation replace it assembled.


1. Disconnect a wire from the negative plug of the storage battery.
2. Remove a belt of a drive of hinged units.
3. Remove a gear belt.
4. Remove the pump of the amplifier of a steering to remove an entrance pipe of system of cooling.
5. Remove all details in the sequence shown in drawing.

Installation

PERFORMANCE ORDER
1. Check the water pump on lack of cracks and damages.
2. Turn a shaft of the water pump and check smoothness of rotation in the absence of noise.
3. If necessary replace the water pump.

Installation

PERFORMANCE ORDER
1. Clear of the remains of laying and an alien material a surface of consolidation of the water pump.
2. Establish on the water pump new laying.
Exclude laying falling as the layer of hermetic put on laying, can be damaged. Establish laying by the party with hermetic to a condensed surface.
3. Further installation is carried out to sequences, return to removal.
4. Fill in in cooling system necessary amount of demanded cooling liquid.
5. Connect a wire to the negative plug of the storage battery.
6. Start up the engine and check absence of leaks from cooling system.