KIA RIO

since 2000 of release

Repair and car operation



Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
- 6. Ignition system
   6.1. Specifications
   6.2. Work of system of ignition
   6.3. Components of system of ignition
   6.4. Corner of an advancing of ignition
   6.5. Ignition coil
   6.6. Spark plugs
   6.7. High-voltage wires
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment


6.4. Corner of an advancing of ignition

GENERAL INFORMATION

Change of installation of a corner of an advancing of ignition can be caused by two reasons: a problem with the sensor which will be found by the control unit the engine or the wrong installation of a camshaft in relation to a cranked shaft. The last problem is connected with the wrong installation of a gear belt of a drive of the gas-distributing mechanism.

No adjustment after replacement of the coil of ignition is required.

Check

PERFORMANCE ORDER
1. Start up the engine and warm up it to working temperature.
2. Switch off everything consumers of electric energy.
3. Connect to the engine a tachometer and to a high-voltage wire of the first cylinder the stroboscope sensor.
4. On combination of labels on a pulley of a cranked shaft with the index check a corner of an advancing of ignition.

Corner of an advancing of ignition: 8±5 ° to VMT (6 °± 5 ° for Europe) (on frequency of rotation of idling)


Prevention

The corner of an advancing of ignition is not regulated.