KIA RIO

since 2000 of release

Repair and car operation

Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
- 9. Axes and power shafts
   9.1. Specifications
   9.2. Check of a condition of a protective cover
   9.3. Check of reliability of shlitsevy connection
   9.4. Replacement of a power shaft
   9.5. Repair of a power shaft
   - 9.6. Forward axis
      9.6.1. Check люфта bearings of forward wheels
      9.6.2. Rotary fist and nave of a forward wheel
      9.6.3. Bearing of a nave of a forward wheel
      9.6.4. Adjustment of a tightness of bearings of a nave of a forward wheel
   9.7. Back axis
   9.8. Adjustment of a tightness of bearings of a back wheel
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment

9.6. Forward axis

GENERAL INFORMATION

Rotary fist and nave of a forward wheel

1–tip of steering draft;
2–rotary fist;
3–brake board;
4–rasporny plug;
5–external bearing;
6–external oil sealing ring;

7–nave;
8–nut;
9–spherical hinge of the bottom lever;
10-internal bearing;
11-internal oil sealing ring.

The forward wheels of the car fixed on a forward suspension bracket, are intended for transfer of a torque of the engine, driving and its braking. For torque transfer forward wheels incorporate to a transmission power shafts.

The rotary fist is an element on which the wheel nave fastens, and also is used as a suspension bracket and steering element. For turn of a rotary fist the hinge of a tip of steering draft is connected to it. As the suspension bracket element a rotary fist is connected to resistant MacPherson and the bottom lever of a forward suspension bracket.

Elements of brake system are the supports fixed on a rotary fist and brake disks, fixed on naves.

The nave of a forward wheel is established in a rotary fist on two conic bearings.
Fastening of a power shaft to a nave is carried out by a nut with a fillet. For an exception of an otvorachivaniye of a nut the fillet of a nut is bent in dredging of a power shaft. After an otvorachivaniye of nuts them it is necessary to replace each time with the new.