Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
- 10. Suspension bracket
10.1. Specifications
10.2. Check of elements of a forward suspension bracket
10.3. Check and adjustment of corners of installation of wheels
10.4. Convergence of forward wheels
10.5. Rack of a forward suspension bracket
10.6. Bottom lever of a forward suspension bracket
10.7. Forward stabilizer of cross-section stability
10.8. Beam of a back suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment
|
Preliminary check
| PERFORMANCE ORDER |
| 1. Check pressure in tires and, if necessary, finish to the demanded. |
| 2. Check люфт bearings of forward wheels and, if necessary, replace. |
| 3. Check palpation of tires and wheels. |
| 4. Check absence люфта spherical hinges of a forward suspension bracket |
| 5. The car should be on a flat horizontal surface without passengers and cargo in a luggage carrier. |
| 6. Distinction in height between the left and right side of the car from the wheel center to edge of a wing should not exceed 10 mm. |
Prevention
Disorder and corner rotary шкворня are not regulated.
|
| 7. Check that a fuel tank full, levels of cooling liquid and engine oil both the spare wheel and tools are in norm on the places. |
|
Check of the maximum angle of rotation of forward wheels
| PERFORMANCE ORDER |
| 1. Establish both lobbies of a wheel in a template of radius of turn. |
| 2. Turn forward wheels to the left against the stop and measure an angle of rotation left (internal) and right (external) wheels. |
| 3. Weaken the left and right lock-nuts of tips of steering drafts, then, rotating drafts, establish demanded corners. Tighten lock-nuts. |
|
4. Repeat these operations after turn of forward wheels to the right against the stop. |
|
5. Tighten lock-nuts of tips of steering drafts. Inhaling moment: 34–50 N • m
|
| 6. Check and, if necessary, adjust a convergence after check and adjustment of the maximum angle of rotation of forward wheels. |
|
|
|