Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
- 10. Suspension bracket
10.1. Specifications
10.2. Check of elements of a forward suspension bracket
10.3. Check and adjustment of corners of installation of wheels
10.4. Convergence of forward wheels
10.5. Rack of a forward suspension bracket
10.6. Bottom lever of a forward suspension bracket
10.7. Forward stabilizer of cross-section stability
10.8. Beam of a back suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment
|
Forward stabilizer of cross-section stability
1–draft of the stabilizer;
2–nut;
3–nut;
4–rubber plug of the stabilizer; |
5–stabilizer arm;
6–assembly bolt;
7–bolt;
8–stabilizer of cross-section stability. |
Removal
| PERFORMANCE ORDER |
|
1. The AA0 adaptation OK201 170 support the engine. |
| 2. Lift a forward part of the car and fix on support. |
| 3. Remove a wheel. |
| 4. Disconnect draft of the stabilizer from the stabilizer of cross-section stability. |
|
5. Unscrew a nut and disconnect draft of the stabilizer of cross-section stability from a rack of a forward suspension bracket. |
| 6. Remove arms of fastening of the stabilizer of cross-section stability. |
|
7. Turn out bolts of fastening of a forward part of a plate of protection of the engine. |
| 8. Lower a forward part of a plate of protection of the engine so that it was possible to take the stabilizer. |
| 9. Remove the stabilizer of cross-section stability. |
|
Check
Check the following places and restore or, if necessary, replace details:
– wear or damage of rubber plugs;
– existence of deformation or stabilizer cracks. Installation
| PERFORMANCE ORDER |
|
1. Establish the stabilizer plug according to the adjusting labels put on the stabilizer. |
| 2. Establish the stabilizer behind a plate of protection of the engine. |
|
|
3. Lift a forward part of a plate of protection of the engine and fix it bolts and nuts. Inhaling moment:
Bolts: 65–90 N • m
Nuts: 39–52 N • m
|
|
|
4. Establish arms of fastening of the stabilizer and fix bolts, having tightened them the demanded moment. Inhaling moment: 36–56 N • m
|
| 5. Establish drafts of the stabilizer on arms and fix them nuts. Inhaling moment: 43–60 N • m
|
| 6. Establish drafts of the stabilizer on the stabilizer and fix them nuts. Inhaling moment: 43–60 N • m
|
Prevention
Tighten nuts of fastening of drafts of the stabilizer the demanded moment after car installation on wheels (under loading).
|
| 7. Establish a wheel. |
| 8. Lower the car. |
| 9. Remove the AA0A adaptation OK201 170 supporting the engine. |
|
|
|
|
|
