KIA RIO

since 2000 of release

Repair and car operation



Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
- 10. Suspension bracket
   10.1. Specifications
   10.2. Check of elements of a forward suspension bracket
   10.3. Check and adjustment of corners of installation of wheels
   10.4. Convergence of forward wheels
   10.5. Rack of a forward suspension bracket
   10.6. Bottom lever of a forward suspension bracket
   10.7. Forward stabilizer of cross-section stability
   10.8. Beam of a back suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment


10.6. Bottom lever of a forward suspension bracket

GENERAL INFORMATION

Bottom lever of a forward suspension bracket

1–bolt;
2–nuts;
3–plug;
4–bottom lever;
5–longitudinal draft.

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and fix on support.
2. Remove a wheel.
3. Turn out a bolt of fastening of the longitudinal lever to a body arm.
4. Turn out two nuts of fastening of the longitudinal lever to the bottom lever.
5. Remove the longitudinal lever from the bottom lever and remove the forward plug and a washer.
6. Turn out a nut and remove a bolt of fastening of a pin of the spherical hinge to a rotary fist. Separate the hinge of the bottom lever from the rotary lever.
7. Unscrew a nut, take a bolt and separate an internal part of the bottom lever from a body arm.

Check

Check the following places and restore or, if necessary, replace details:

      – existence of deformation or cracks in the bottom lever;
      – wear or damage of rubber plugs;
      – there does not correspond to demanded value the moment of a provorachivaniye of a pin of the spherical hinge of the bottom lever.

Installation
PERFORMANCE ORDER

1. Fix the spherical hinge in a vice. Establish on a pin of the spherical hinge of the bottom lever the special adaptation ОК130 322 020, hook for it on a dynamometer and measure the moment of a provorachivaniye of a pin.

Moment of a provorachivaniye of a pin of the spherical hinge: 1,0–3,5 N • m
The moment on a device scale: 10–35 N

2. Establish an internal part of the lever in an arm of a body and fix a bolt and a nut, having tightened them by hand.
3. Establish a pin of the spherical hinge of the bottom lever in a rotary fist and fix a bolt and a nut.

Inhaling moment: 54–68 N • m

4. Tighten a bolt of fastening of an internal part of the bottom lever to a body arm.

Inhaling moment: 118–147 N • m

5. Establish longitudinal draft on the bottom lever and fix two nuts.
6. Fix a forward part of longitudinal draft on a body.

Inhaling moment: 118–147 N • m