since 2000 of release

Repair and car operation

+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
- 7. Coupling
   7.1. Specifications
   7.2. Adjustment of a pedal of coupling
   7.3. Height of installation of a pedal of coupling
   7.4. Coupling disk
   7.5. Check of a casing of coupling with a press disk
   7.6. Check of a disk of coupling
   7.7. Casing of coupling and press disk
   7.8. Replacement of the central bearing
   7.9. Coupling pedal
   7.10. Coupling cable
   7.11. Bearing of switching off of coupling
   7.12. Fork of switching off of coupling \squeezing lever
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment

7.10. Coupling cable


1. Unscrew adjusting nuts on the squeezing lever so that it was possible to remove a cable from the squeezing lever.
2. Remove an arm of fastening of a cover of a cable of coupling to a transmission.
3. Remove a clip, fixing a cable cover to an arm of a pedal of coupling.
4. Pull a cable up and disconnect it from a hook of a pedal of coupling.
5. If necessary unscrew nuts and remove an arm.
6. Through an opening in a partition of a motor compartment extend a coupling cable.


Check the following details and, if necessary, replace them.

1. The worn-out or damaged plugs.
2. The deformed pedal of coupling.
3. The worn-out or damaged rubber overlay of a pedal of coupling.
4. The damaged cable of coupling.
5. Incorrectly functioning cable of coupling.


Installation is carried out to sequences, return to removal.

Adjust a free wheeling of a pedal of coupling.