KIA RIO

since 2000 of release

Repair and car operation


Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
- 7. Coupling
   7.1. Specifications
   7.2. Adjustment of a pedal of coupling
   7.3. Height of installation of a pedal of coupling
   7.4. Coupling disk
   7.5. Check of a casing of coupling with a press disk
   7.6. Check of a disk of coupling
   7.7. Casing of coupling and press disk
   7.8. Replacement of the central bearing
   7.9. Coupling pedal
   7.10. Coupling cable
   7.11. Bearing of switching off of coupling
   7.12. Fork of switching off of coupling \squeezing lever
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment

7.9. Coupling pedal
GENERAL INFORMATION

Coupling pedal

1–sharnirny bolt;
2–returnable spring;
3–nut;
4–plugs;
 5–clip;
6–coupling pedal;
7–brake pedal;
8–coupling cable.

Removal

PERFORMANCE ORDER
1. Unscrew adjusting nuts on the squeezing lever so that it was possible to remove a cable from the squeezing lever.
2. Remove a clip, fixing a cable cover to an arm of a pedal of coupling.
3. Pull a cable up and disconnect it from a hook of a pedal of coupling.
4. Unscrew nuts and remove spring and flat washers from a sharnirny bolt.
5. Remove a coupling pedal from a sharnirny bolt and returnable springs.
6. If necessary remove a rubber slip from a pedal of coupling and an emphasis.
Prevention

Apply a thin film lithium greasing (NGLI Number 2) on plugs and points of turn of a pedal.

Installation

Installation is carried out to sequences, return to removal.