KIA RIO

since 2000 of release

Repair and car operation



Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
- 7. Coupling
   7.1. Specifications
   7.2. Adjustment of a pedal of coupling
   7.3. Height of installation of a pedal of coupling
   7.4. Coupling disk
   7.5. Check of a casing of coupling with a press disk
   7.6. Check of a disk of coupling
   7.7. Casing of coupling and press disk
   7.8. Replacement of the central bearing
   7.9. Coupling pedal
   7.10. Coupling cable
   7.11. Bearing of switching off of coupling
   7.12. Fork of switching off of coupling \squeezing lever
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment


7.6. Check of a disk of coupling

PERFORMANCE ORDER
1. Check a condition of frictional overlays of a disk of coupling and in the presence of oil traces on them or mechanical damages replace a coupling disk.

Prevention

Insignificant pollution remove with a fine-grained emery paper.


2. Check reliability of zaklepochny connections of frictional slips to a coupling disk. In the presence of defects replace a coupling disk.
3. Check a vystupaniye of frictional slips over heads of rivets. If a vystupaniye less admissible, replace a coupling disk.

Vystupaniye: 0,3 mm

4. Establish a coupling disk on an opravka in the centers and by the indicator of hour type measure its palpation. If palpation is higher admissible, replace a coupling disk.

Axial palpation: 0,7 mm
Radial palpation: 1,0 mm

5. Check a coupling disk on lack of a rust in shlitsa. In the presence of a rust, remove it.

Installation

PERFORMANCE ORDER
1. Establish a disk of coupling and center it a special opravka ОК130 160 010.

Prevention

Combine labels on a flywheel and a casing the couplings put before removal.


2. Establish a casing of coupling with a press disk on directing pins of a flywheel.

3. Gradually in diagonal sequence and in a certain order tighten bolts of fastening of a flywheel.

Inhaling moment: 18–26 N • m

4. Remove a special opravka ОК130 160 010.

Prevention

Before installation of a transmission clear shlitsa in a nave of a disk of coupling and put on them a thin layer of greasing on the basis of a molybdenum disulfide.


5. Establish a transmission.