KIA RIO

since 2000 of release

Repair and car operation



Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
- 7. Coupling
   7.1. Specifications
   7.2. Adjustment of a pedal of coupling
   7.3. Height of installation of a pedal of coupling
   7.4. Coupling disk
   7.5. Check of a casing of coupling with a press disk
   7.6. Check of a disk of coupling
   7.7. Casing of coupling and press disk
   7.8. Replacement of the central bearing
   7.9. Coupling pedal
   7.10. Coupling cable
   7.11. Bearing of switching off of coupling
   7.12. Fork of switching off of coupling \squeezing lever
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment










7.8. Replacement of the central bearing

Removal

PERFORMANCE ORDER
1. Remove a flywheel.
2. A finger of a hand turn the bearing with the appendix of the maximum effort in the axial direction. If the bearing is turned hardly, replace it.
3. A special stripper take the central bearing from a flywheel.

Installation


Prevention

At installation of the central bearing an opravka it is necessary опирать on an external ring of the bearing. Any contact to an internal ring will damage the bearing.


PERFORMANCE ORDER
1. A hammer and a tubular opravka establish the central bearing.
2. Establish a flywheel.