KIA RIO

since 2000 of release

Repair and car operation



Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
- 9. Axes and power shafts
   9.1. Specifications
   9.2. Check of a condition of a protective cover
   9.3. Check of reliability of shlitsevy connection
   9.4. Replacement of a power shaft
   9.5. Repair of a power shaft
   - 9.6. Forward axis
      9.6.1. Check люфта bearings of forward wheels
      9.6.2. Rotary fist and nave of a forward wheel
      9.6.3. Bearing of a nave of a forward wheel
      9.6.4. Adjustment of a tightness of bearings of a nave of a forward wheel
   9.7. Back axis
   9.8. Adjustment of a tightness of bearings of a back wheel
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment


9.6.4. Adjustment of a tightness of bearings of a nave of a forward wheel

PERFORMANCE ORDER
1. On the special adaptation ОК130 331 016 insert two bearings of a wheel and the removed rasporny plug into a rotary fist.
2. Fix on the basis the special adaptation ОК130 331 016.

3. Tighten a nut of the special adaptation ОК130 331 016 the demanded moment.

Inhaling moment: 157–235 N • m


Prevention

Tightening of a nut carry out evenly, increasing the inhaling moment each time by 5 N • m to prevent an excessive preliminary tightness.


4. Turn a rotary fist for the correct installation of rollers of bearings.

5. By the special adaptation ОК130 322 020 measure a preliminary tightness of bearings.

Preliminary tightness of bearings: 0,25–1,17 N • m (2,5–11,7 N)

6. If the preliminary tightness of bearings does not correspond to demanded value, from the table pick up the rasporny plug of the corresponding thickness.

Prevention

For reduction of a tightness of bearings increase thickness of the rasporny plug and on the contrary. At change of thickness of the rasporny plug on 1 category the tightness of bearings changes on 0,2-0,4 N • m. Marking is put on outer side of the rasporny plug.


Marking
Thickness, mm
1
6,285
2
6,325
3
6,365
4
6,405
5
6,445
6
6,485
7
6,525
8
6,565
9
6,605
10
6,645
11
6,685
12
6,725
13
6,765
14
6,805
15
6,845
16
6,885
17
6,925
18
6,965
19
7,005
20
7,045
21
7,085

7. Remove the special adaptation ОК130 322 020. Remove external and internal bearings and the rasporny plug.

Prevention

Completely fill with lithium lubricant the shaded area shown in drawing.