KIA RIO

since 2000 of release

Repair and car operation


Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
- 15. Air central air
   15.1. Specifications
   15.2. Contour of central air of air
   15.3. Remarks at replacement of elements of central air of air
   15.4. Connection of elements of central air of air
   15.5. Precautionary measures
   15.6. Verification of operational characteristics
   15.7. Diagnostics air central air with use of manometers
   15.8. Check of a gap of coupling of the compressor of the conditioner
   15.9. Check of coupling of the compressor of the conditioner
   15.10. Oil for greasing of the compressor of the conditioner
   15.11. Check of level and an oil dolivka in the conditioner compressor
   15.12. Air filter of the evaporator
   15.13. Sensor of double pressure
   15.14. Conditioner compressor
   15.15. Condenser check
   15.16. Check of the fan of the condenser
   15.17. Receiver \dryer check
   15.18. Check of the thermostatic sensor (termistor)
   15.19. Check of the engine of the fan
   15.20. Check of the block of resistors of the engine of the fan
   15.21. The switch of supply of air in car salon
   15.22. Control panel air central air
+ 16. Electric equipment

15.11. Check of level and an oil dolivka in the conditioner compressor
PERFORMANCE ORDER
1. Stop the engine, discharge central air of air and remove the conditioner compressor.
2. Merge oil from the conditioner compressor.
3. Measure volume of the merged oil. If it less than 70 cm3, means, there is an insignificant leak. Define a place of leak and repair or replace faulty details.

4. Check extent of pollution of oil and fill in it in the following order:

      – if oil pure:

Discharge
Filling
About 70 cm3 Oil level in norm. Add the same amount of oil, as well as it was merged at a discharge.
Less than 70 cm3 Level of oil is lower than norm. Add 70 cm3 of oil.

      – if oil is polluted by metal particles, clear the dryer / receiver after a coolant charging.