KIA RIO

since 2000 of release

Repair and car operation



Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
- 15. Air central air
   15.1. Specifications
   15.2. Contour of central air of air
   15.3. Remarks at replacement of elements of central air of air
   15.4. Connection of elements of central air of air
   15.5. Precautionary measures
   15.6. Verification of operational characteristics
   15.7. Diagnostics air central air with use of manometers
   15.8. Check of a gap of coupling of the compressor of the conditioner
   15.9. Check of coupling of the compressor of the conditioner
   15.10. Oil for greasing of the compressor of the conditioner
   15.11. Check of level and an oil dolivka in the conditioner compressor
   15.12. Air filter of the evaporator
   15.13. Sensor of double pressure
   15.14. Conditioner compressor
   15.15. Condenser check
   15.16. Check of the fan of the condenser
   15.17. Receiver \dryer check
   15.18. Check of the thermostatic sensor (termistor)
   15.19. Check of the engine of the fan
   15.20. Check of the block of resistors of the engine of the fan
   15.21. The switch of supply of air in car salon
   15.22. Control panel air central air
+ 16. Electric equipment





15.6. Verification of operational characteristics

GENERAL INFORMATION


PERFORMANCE ORDER
1. Establish a manometer on a collector.
2. Start up the engine, leave to work at frequency of rotation of a cranked shaft of 2000 mines-1 and establish a mode of the maximum cooling, at high frequency of rotation of the fan.
3. Open all windows or doors.
4. Establish the thermometer in a lattice of supply of air in car salon.
5. Establish damp and dry thermometers as it is possible closer to an entrance opening of the block of cooling.
6. Check that the pressure shown by a manometer, is in limits of 1,373-1,575 kPa. If pressure too high, pour water on the condenser. If pressure too low, close the forward party of the condenser.
7. Check that air temperature in a lattice of supply of air in salon of the car is in limits 25–35°C.
8. According to the schedule calculate relative humidity of air, comparing temperature of damp and dry thermometers.
9. Take temperature in a lattice of supply of air in salon of the car and calculate a difference the dry thermometer and the thermometer in a lattice of supply of air.
10. Check that if crossing of relative humidity and a difference of temperatures are in admission limits, means, central air of air works normally.