KIA RIO

since 2000 of release

Repair and car operation


Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
- 15. Air central air
   15.1. Specifications
   15.2. Contour of central air of air
   15.3. Remarks at replacement of elements of central air of air
   15.4. Connection of elements of central air of air
   15.5. Precautionary measures
   15.6. Verification of operational characteristics
   15.7. Diagnostics air central air with use of manometers
   15.8. Check of a gap of coupling of the compressor of the conditioner
   15.9. Check of coupling of the compressor of the conditioner
   15.10. Oil for greasing of the compressor of the conditioner
   15.11. Check of level and an oil dolivka in the conditioner compressor
   15.12. Air filter of the evaporator
   15.13. Sensor of double pressure
   15.14. Conditioner compressor
   15.15. Condenser check
   15.16. Check of the fan of the condenser
   15.17. Receiver \dryer check
   15.18. Check of the thermostatic sensor (termistor)
   15.19. Check of the engine of the fan
   15.20. Check of the block of resistors of the engine of the fan
   15.21. The switch of supply of air in car salon
   15.22. Control panel air central air
+ 16. Electric equipment

15.14. Conditioner compressor

Removal and installation

PERFORMANCE ORDER
1. On cars without the amplifier of a steering weaken a bolt of A of fastening of the mechanism of a tension, weaken an adjusting bolt In and remove a belt of a drive of the compressor of the conditioner.
2. On cars with the amplifier of a steering weaken bolts of A, B and C, weaken an adjusting bolt of D and remove a belt of a drive of the compressor of the conditioner.
3. Discharge air central air.
4. Disconnect hoses from the conditioner compressor.
5. Remove the conditioner compressor. Immediately close all open openings and tubes for an exception of hit of moisture of air in air central air.
6. Installation of the compressor of the conditioner is carried out to sequences, return to removal, taking into account the following:

      – fill in in the compressor fresh oil;
      – before installation of sealing rings, oil them;
      – do not grease connecting nuts of unions of the compressor of the conditioner;
      – tighten entrance and target hoses the demanded moment;
      – adjust a tension of a belt of a drive of the compressor of the conditioner.

Inhaling moment: 24–36 N • m

7. Fill with a coolant air central air.