KIA RIO

since 2000 of release

Repair and car operation



Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
- 16. Electric equipment
   16.1. Specifications
   16.2. Electric chains
   + 16.3. Generator
   + 16.4. Storage battery
   16.5. Starter
   16.6. Check at a provorachivaniye of a cranked shaft not the heated-up engine
   16.7. Check of an electric chain of the traction relay
   16.8. Check of the traction relay
   16.9. Check of brushes and shchetkoderzhatel
   16.10. Check of coils of a stator
   16.11. Rotor check
   16.12. Removal and starter installation
   16.13. Starter repair
   16.14. Multipurpose switch
   16.15. Sound signal
   16.16. The block of safety locks and the relay, established in car salon
   16.17. Check of the relay of the activator of the lock of a door
   16.18. Check of the switch of adjustment of provision of an external rear-view mirror
   16.19. Check of the activator of provision of an external rear-view mirror
   16.20. Check of the engine of a window regulator
   16.21. Check of a heater of back glass
   16.22. Repair of a current-carrying strip of a heater
   16.23. Engine of a screen wiper of a windscreen
   16.24. Stekloomyvateli
   16.25. Adjustment of light of headlights
   16.26. Adjustment of light of fog lights
   16.27. Safety cushions (SRS)
   16.28. Precautionary labels
   16.29. Safety cushion of the driver and spiral wire
   16.30. Safety cushion check
   16.31. Check of a spiral wire (spring)
   16.32. Safety cushion of the forward passenger
   + 16.33. Electric circuits


Обслуживание и ремонт кондиционеров читайте здесь.

16.22. Repair of a current-carrying strip of a heater

GENERAL INFORMATION

For repair of a current-carrying strip of a heater prepare the following materials and tools:

      – current-carrying weight;
      – melkodispersny current-carrying weight;
      – sticky tape;
      – solvent;
      – brush.

Solvent wipe glass area about a rupture of a current-carrying strip of a heater and paste strips of a sticky tape from two parties of a current-carrying strip.

Put with an interval in 15 mines three layers of current-carrying weight. Remove a sticky tape and wait the current-carrying weight will not dry yet. In 24 hours with a sharp knife remove surpluses of current-carrying weight.


Prevention

After restoration of a current-carrying strip of a heater, purification of glass carry out along a strip of a heater a little humidified rags.