KIA RIO

since 2000 of release

Repair and car operation

Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
- 16. Electric equipment
   16.1. Specifications
   16.2. Electric chains
   + 16.3. Generator
   + 16.4. Storage battery
   16.5. Starter
   16.6. Check at a provorachivaniye of a cranked shaft not the heated-up engine
   16.7. Check of an electric chain of the traction relay
   16.8. Check of the traction relay
   16.9. Check of brushes and shchetkoderzhatel
   16.10. Check of coils of a stator
   16.11. Rotor check
   16.12. Removal and starter installation
   16.13. Starter repair
   16.14. Multipurpose switch
   16.15. Sound signal
   16.16. The block of safety locks and the relay, established in car salon
   16.17. Check of the relay of the activator of the lock of a door
   16.18. Check of the switch of adjustment of provision of an external rear-view mirror
   16.19. Check of the activator of provision of an external rear-view mirror
   16.20. Check of the engine of a window regulator
   16.21. Check of a heater of back glass
   16.22. Repair of a current-carrying strip of a heater
   16.23. Engine of a screen wiper of a windscreen
   16.24. Stekloomyvateli
   16.25. Adjustment of light of headlights
   16.26. Adjustment of light of fog lights
   16.27. Safety cushions (SRS)
   16.28. Precautionary labels
   16.29. Safety cushion of the driver and spiral wire
   16.30. Safety cushion check
   16.31. Check of a spiral wire (spring)
   16.32. Safety cushion of the forward passenger
   + 16.33. Electric circuits

16.6. Check at a provorachivaniye of a cranked shaft not the heated-up engine

PERFORMANCE ORDER

1. Connect щупы the digital voltmeter to plugs of the storage battery.

2. Be convinced that the parking brake is completely tightened. On cars with an automatic transmission establish the selector lever in PARK position. On cars with a mechanical transmission establish the gear shifting lever in neutral situation.

3. Be convinced that all consumers of electric energy are switched off.

4. Include ignition and a starter and watch voltmeter indications.

5. If tension is lower 9,6 In, remove a starter and carry out bench tests. If bench tests yielded negative result, replace a starter.

6. If tension is higher 9,6 In, and the consumed current is lower than demanded value, inspect on power failure.

7. If the tension shown by the voltmeter 12,5 B or more, and a starter does not work, check operability of the traction relay.

8. If the tension shown by the voltmeter 12,5 B or more and a starter turns a cranked shaft of the engine very slowly, inspect on power failure.