KIA RIO

since 2000 of release

Repair and car operation



Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
- 16. Electric equipment
   16.1. Specifications
   16.2. Electric chains
   + 16.3. Generator
   + 16.4. Storage battery
   16.5. Starter
   16.6. Check at a provorachivaniye of a cranked shaft not the heated-up engine
   16.7. Check of an electric chain of the traction relay
   16.8. Check of the traction relay
   16.9. Check of brushes and shchetkoderzhatel
   16.10. Check of coils of a stator
   16.11. Rotor check
   16.12. Removal and starter installation
   16.13. Starter repair
   16.14. Multipurpose switch
   16.15. Sound signal
   16.16. The block of safety locks and the relay, established in car salon
   16.17. Check of the relay of the activator of the lock of a door
   16.18. Check of the switch of adjustment of provision of an external rear-view mirror
   16.19. Check of the activator of provision of an external rear-view mirror
   16.20. Check of the engine of a window regulator
   16.21. Check of a heater of back glass
   16.22. Repair of a current-carrying strip of a heater
   16.23. Engine of a screen wiper of a windscreen
   16.24. Stekloomyvateli
   16.25. Adjustment of light of headlights
   16.26. Adjustment of light of fog lights
   16.27. Safety cushions (SRS)
   16.28. Precautionary labels
   16.29. Safety cushion of the driver and spiral wire
   16.30. Safety cushion check
   16.31. Check of a spiral wire (spring)
   16.32. Safety cushion of the forward passenger
   + 16.33. Electric circuits


16.25. Adjustment of light of headlights

GENERAL INFORMATION

Light of headlights should be adjusted with use of the special equipment and according to instructions of the manufacturer of the equipment.

Serially rotate adjusting wheels to adjust a stream of light of headlights.

If the special equipment is not available, execute adjustment as follows:

PERFORMANCE ORDER
1. Finish pressure in tires to the demanded. In the car there should be only a driver, the tool and a spare wheel.
2. Establish the car on an equal horizontal surface in front of the screen or a wall.
3. On the screen carry out the vertical lines passing through the center of each headlight and the horizontal line, being on the center of headlights.

4. Include headlights and, rotating adjusting wheels, adjust their situation so that the most light spot settled down according to the shaded area.



H1: Height between the filament lamp of a headlight and the earth.
H2: The height between the filament lamp of a fog light concentrates also the earth.
W1: Distance between centers filament lamps of headlights.
W2: Distance between centers filament lamps of fog lights.
L: Distance between the filament lamp of a headlight and the screen.