KIA RIO

since 2000 of release

Repair and car operation



Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
- 13. Brake system
   13.1. Specifications
   13.2. Check of the vacuum amplifier of brakes with use of devices
   13.3. Unilateral vacuum valve
   13.4. Vacuum amplifier of brakes
   13.5. Pumping of hydraulic system of a drive of brakes
   13.6. Check of brake tubes
   13.7. Check and replacement of brake hoses
   + 13.8. Brake pedal
   13.9. Replacement of forward brake shoes
   13.10. Replacement of brake shoes on back drum-type brakes
   13.11. Repair of a support of a forward brake
   13.12. Repair of the working brake cylinder
   13.13. Main brake cylinder
   13.14. Pressure limiter
   13.15. Parking brake
   13.16. ABS control unit
   13.17. Block of hydraulic management (HCU)
   13.18. Forward sensor of frequency of rotation of a wheel
   13.19. Back sensor of frequency of rotation of a wheel
   + 13.20. Gear rotor of the sensor of frequency of rotation of a wheel
   13.21. Main survey
   13.22. Check of functionality
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment


13.17. Block of hydraulic management (HCU)

GENERAL INFORMATION

Block of hydraulic management (HCU)

1–block of hydraulic management (HCU);

2–HCU arm;

3–brake tube;

4–socket

Removal

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. Having pulled, release a clamp and disconnect the socket from the block of hydraulic management.
3. A cap wrench disconnect brake tubes. Collect the leaked brake liquid.
Temporarily close the ends of tubes plastic jams for an exception of hit of pollution in them.
4. A cap wrench turn out bolts and nuts of fastening of an arm of the block of hydraulic management and remove an arm.
5. Temporarily close openings in the block plastic jams for an exception of hit of pollution in them.
6. Store the block of hydraulic management in the protective container.

Installation

PERFORMANCE ORDER
1. Establish an arm of the block of hydraulic management on the car and fix bolts and nuts.
2. Repeatedly connect tubes of brake system.
3. Connect the socket to the block of hydraulic management.
4. Remove air from a hydraulic contour of brake system.