KIA RIO

since 2000 of release

Repair and car operation



Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
- 13. Brake system
   13.1. Specifications
   13.2. Check of the vacuum amplifier of brakes with use of devices
   13.3. Unilateral vacuum valve
   13.4. Vacuum amplifier of brakes
   13.5. Pumping of hydraulic system of a drive of brakes
   13.6. Check of brake tubes
   13.7. Check and replacement of brake hoses
   + 13.8. Brake pedal
   13.9. Replacement of forward brake shoes
   13.10. Replacement of brake shoes on back drum-type brakes
   13.11. Repair of a support of a forward brake
   13.12. Repair of the working brake cylinder
   13.13. Main brake cylinder
   13.14. Pressure limiter
   13.15. Parking brake
   13.16. ABS control unit
   13.17. Block of hydraulic management (HCU)
   13.18. Forward sensor of frequency of rotation of a wheel
   13.19. Back sensor of frequency of rotation of a wheel
   + 13.20. Gear rotor of the sensor of frequency of rotation of a wheel
   13.21. Main survey
   13.22. Check of functionality
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment





13.5. Pumping of hydraulic system of a drive of brakes

GENERAL INFORMATION

Any hydraulic system works normally if air is removed from it.

PERFORMANCE ORDER
1. Lift the car and fix on support.

Prevention

Liquid in a popolnitelny tank of brake system should be supported at level 3/4 or is higher in the course of pumping.

During removal of air add only pure liquid recommended by the manufacturer.


2. Unscrew a cover from the union of pumping and attach to it a hose.
3. Arrange other end of a hose in glass capacity of sufficient volume.
4. Slowly press a brake pedal several times.

5. At the pressed pedal of a brake a key OK130 430 019 weaken the union of pumping and let the air out from hydraulic system.

Prevention

The pedal of a brake should be pressed until the union of pumping will not be tightened.


6. Repeat operations 4-5 until there will be a brake liquid without air vials.
7. Check correctness of work of brakes.
8. Check absence of leakages of brake liquid.
9. Add brake liquid in a popolnitelny tank of brake system.

Inhaling moment: 5,9–8,8 N • m