KIA RIO

since 2000 of release

Repair and car operation



Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
- 13. Brake system
   13.1. Specifications
   13.2. Check of the vacuum amplifier of brakes with use of devices
   13.3. Unilateral vacuum valve
   13.4. Vacuum amplifier of brakes
   13.5. Pumping of hydraulic system of a drive of brakes
   13.6. Check of brake tubes
   13.7. Check and replacement of brake hoses
   + 13.8. Brake pedal
   13.9. Replacement of forward brake shoes
   13.10. Replacement of brake shoes on back drum-type brakes
   13.11. Repair of a support of a forward brake
   13.12. Repair of the working brake cylinder
   13.13. Main brake cylinder
   13.14. Pressure limiter
   13.15. Parking brake
   13.16. ABS control unit
   13.17. Block of hydraulic management (HCU)
   13.18. Forward sensor of frequency of rotation of a wheel
   13.19. Back sensor of frequency of rotation of a wheel
   + 13.20. Gear rotor of the sensor of frequency of rotation of a wheel
   13.21. Main survey
   13.22. Check of functionality
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment


13.4. Vacuum amplifier of brakes

GENERAL INFORMATION

Vacuum amplifier of brakes

1–brake tube;
2–nuts;
3–electric socket;
4–main brake cylinder;
5–laying;
6–vacuum hose;
7–шплинт;
8–a pin with a head and an opening under шплинт;
9–nuts;
10-vacuum amplifier of brakes.

Removal

PERFORMANCE ORDER
1. Disconnect the electric socket from a popolnitelny tank with brake liquid.
2. Disconnect brake tubes.
3. Remove the main brake cylinder.
4. Disconnect a vacuum hose from the vacuum amplifier of brakes.
5. In salon of the car take шплинт, a fixing pin with a head and an opening under шплинт.
6. Take a pin with a head and an opening under шплинт.
7. The assistant should support the vacuum amplifier of brakes in a motor compartment.
8. Unscrew four nuts of fastening of the vacuum amplifier of brakes to a partition of a motor compartment.
9. Remove the vacuum amplifier of brakes.
10. Remove laying of an arm of the vacuum amplifier of brakes.

Installation


Prevention

Grease a pin with a head and an opening under шплинт lithium greasing.


PERFORMANCE ORDER
1. Installation is carried out to sequences of return to removal.

Inhaling moment: 18,6–25,5 N • m

2. Fill a popolnitelny tank of brake system with brake liquid to a label the MOVE.
3. Remove air from a hydraulic contour of brake system.
4. Check absence of leakages of brake liquid.
5. Check and, if necessary, adjust height of installation of a pedal and a free wheeling of a pedal of a brake.