KIA RIO

since 2000 of release

Repair and car operation


Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
- 13. Brake system
   13.1. Specifications
   13.2. Check of the vacuum amplifier of brakes with use of devices
   13.3. Unilateral vacuum valve
   13.4. Vacuum amplifier of brakes
   13.5. Pumping of hydraulic system of a drive of brakes
   13.6. Check of brake tubes
   13.7. Check and replacement of brake hoses
   + 13.8. Brake pedal
   13.9. Replacement of forward brake shoes
   13.10. Replacement of brake shoes on back drum-type brakes
   13.11. Repair of a support of a forward brake
   13.12. Repair of the working brake cylinder
   13.13. Main brake cylinder
   13.14. Pressure limiter
   13.15. Parking brake
   13.16. ABS control unit
   13.17. Block of hydraulic management (HCU)
   13.18. Forward sensor of frequency of rotation of a wheel
   13.19. Back sensor of frequency of rotation of a wheel
   + 13.20. Gear rotor of the sensor of frequency of rotation of a wheel
   13.21. Main survey
   13.22. Check of functionality
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment

13.18. Forward sensor of frequency of rotation of a wheel

Removal

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. Turn out the sensor from a rotary fist.
3. Remove a clip of fastening of a wire of the sensor.
4. After removal of furnish remove the sensor of frequency of rotation of a wheel and the socket in a motor compartment.

Check

PERFORMANCE ORDER
1. Measure resistance of the sensor of frequency of rotation of a wheel.

Resistance: 1.3–1.5 kiloohm

2. If necessary replace the sensor of frequency of rotation of a wheel.

Installation

PERFORMANCE ORDER
1. Establish the sensor of frequency of rotation of a wheel and connect the socket.

Inhaling moment: 8–12 N • m

2. Establish furnish.
3. Establish the ABS sensor to a clip.
4. Establish the ABS sensor in a rotary fist.
5. Connect a wire to the negative plug of the storage battery.