KIA RIO

since 2000 of release

Repair and car operation


Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
- 13. Brake system
   13.1. Specifications
   13.2. Check of the vacuum amplifier of brakes with use of devices
   13.3. Unilateral vacuum valve
   13.4. Vacuum amplifier of brakes
   13.5. Pumping of hydraulic system of a drive of brakes
   13.6. Check of brake tubes
   13.7. Check and replacement of brake hoses
   - 13.8. Brake pedal
      13.8.1. Height of installation of a pedal of a brake
      13.8.2. Free wheeling of a pedal of a brake
      13.8.3. Distance of a pedal of a brake from a floor
   13.9. Replacement of forward brake shoes
   13.10. Replacement of brake shoes on back drum-type brakes
   13.11. Repair of a support of a forward brake
   13.12. Repair of the working brake cylinder
   13.13. Main brake cylinder
   13.14. Pressure limiter
   13.15. Parking brake
   13.16. ABS control unit
   13.17. Block of hydraulic management (HCU)
   13.18. Forward sensor of frequency of rotation of a wheel
   13.19. Back sensor of frequency of rotation of a wheel
   + 13.20. Gear rotor of the sensor of frequency of rotation of a wheel
   13.21. Main survey
   13.22. Check of functionality
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment

13.8. Brake pedal
GENERAL INFORMATION

Brake pedal

1–lock washer;
2–nut;
3–bolt;
4–plug;
5–rasporny plug; 		6–a pin with a head and an opening under шплинт;
7–returnable spring;
8–шплинт;
9–rubber emphasis;
10-brake pedal.

Removal

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. In salon of the car take шплинт, a fixing pin with a head and an opening under шплинт and take a pin.
3. Unscrew a nut and remove a lock washer.
4. Remove the rasporny plug from a sharnirny bolt.
5. Move a bolt to the right and remove it.
6. Remove a brake pedal, a returnable spring and rasporny plugs.
7. If necessary remove an overlay of a pedal of a brake and a rubber emphasis.

Installation

PERFORMANCE ORDER
1. If necessary establish a rubber emphasis of a pedal of a brake, a pedal of a brake and the plug of a pedal of a brake.
2. Establish the rasporny plug of a pedal of a brake and a sharnirny bolt.
3. Establish a returnable spring of a pedal of a brake.
4. Establish a coupling pedal.
5. Establish the rasporny plug of a pedal of coupling.
6. Establish a sharnirny bolt, a washer and screw a nut.
7. Establish a pin with a head and an opening under шплинт and new шплинт.
8. Connect a wire to the negative plug of the storage battery.
9. After installation check and adjust height of installation of a pedal and a free wheeling of a pedal of a brake.