KIA RIO

since 2000 of release

Repair and car operation



Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
- 13. Brake system
   13.1. Specifications
   13.2. Check of the vacuum amplifier of brakes with use of devices
   13.3. Unilateral vacuum valve
   13.4. Vacuum amplifier of brakes
   13.5. Pumping of hydraulic system of a drive of brakes
   13.6. Check of brake tubes
   13.7. Check and replacement of brake hoses
   - 13.8. Brake pedal
      13.8.1. Height of installation of a pedal of a brake
      13.8.2. Free wheeling of a pedal of a brake
      13.8.3. Distance of a pedal of a brake from a floor
   13.9. Replacement of forward brake shoes
   13.10. Replacement of brake shoes on back drum-type brakes
   13.11. Repair of a support of a forward brake
   13.12. Repair of the working brake cylinder
   13.13. Main brake cylinder
   13.14. Pressure limiter
   13.15. Parking brake
   13.16. ABS control unit
   13.17. Block of hydraulic management (HCU)
   13.18. Forward sensor of frequency of rotation of a wheel
   13.19. Back sensor of frequency of rotation of a wheel
   + 13.20. Gear rotor of the sensor of frequency of rotation of a wheel
   13.21. Main survey
   13.22. Check of functionality
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment


13.8.1. Height of installation of a pedal of a brake

Check


Measure distance from the center of a pedal of a brake to a floor carpet.

Distance: 170176 mm

Adjustment

PERFORMANCE ORDER
1. Disconnect the socket from the switch of stop signals.
2. Weaken a lock-nut of B and rotate the switch while it does not contact with a pedal.
3. Weaken a lock-nut of D and, rotating a pusher of C, adjust height of installation of a pedal of a brake. If necessary turn out the switch to interfere with its contact to a brake pedal.
4. Screw the switch so that its plunzher was completely drowned in the switch case, then turn out the switch on turn S. Tighten lock-nuts of B and D.

Inhaling moment: 23,534,3 N • m

5. Connect the socket to the switch of stop signals and check action of stop signals.