KIA RIO

since 2000 of release

Repair and car operation


Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
- 8. Transmission
   + 8.1. Mechanical transmission
   - 8.2. Automatic transmission of F4E-K
      8.2.1. Specifications
      8.2.2. Check of work and adjustment of position of the lever of the selector
      8.2.3. Testing of collaboration of an automatic transmission and the engine on the motionless car (stall test)
      8.2.4. Testing of a time lag (Lag test)
      8.2.5. Check of pressure of transmission liquid
      8.2.6. Check of level and liquid replacement in an automatic transmission
      8.2.7. Procedure of replacement of liquid in the converter of an automatic transmission
      8.2.8. Leakages of liquid from an automatic transmission
      8.2.9. Replacement of oil sealing rings
      8.2.10. Removal and installation of an automatic transmission
      8.2.11. Repair of an automatic transmission
      8.2.12. Radiator of cooling of liquid of an automatic transmission
      8.2.13. Block of valves
      8.2.14. The case of regulating valves
      8.2.15. Oil pump
      8.2.16. Check of resistance of the sensor of frequency of rotation of an entrance shaft \turbine wheel
      8.2.17. Check of resistance of the sensor of speed
      8.2.18. Switch of operating modes of a transmission of O\D
      8.2.19. Switch of a range of a transmission
      8.2.20. Sensor of temperature of an automatic transmission
      8.2.21. Electromagnetic valves
      8.2.22. Linear electromagnetic valve
      8.2.23. Selector lever
      8.2.24. Repair of the lever of the selector
      8.2.25. Check of functioning of the mechanism of blocking of the lever of the selector
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment

8.2.12. Radiator of cooling of liquid of an automatic transmission
GENERAL INFORMATION

Radiator of cooling of liquid of an automatic transmission

1–target tube of liquid of an automatic transmission (hotter hose);
2–connecting bolt;
3–washer;
4–target hose of liquid of an automatic transmission (hotter hose); 		5–entrance tube of liquid of an automatic transmission (colder hose);
6–radiator;
7–connecting bolt;
8–washer.

Removal

PERFORMANCE ORDER
1. Lift the car and fix on support.
2. Turn out seven screws and remove the right mudguard of a motor compartment.
3. Establish under a radiator the pallet for collecting liquid.
4. Disconnect entrance and target hoses of liquid of an automatic transmission.
5. Remove entrance and target tubes of liquid of an automatic transmission.
6. Remove a radiator.

Installation

PERFORMANCE ORDER
1. Establish a radiator.
2. Establish entrance and target tubes of liquid of an automatic transmission.

Inhaling moment: 32–47 N

3. Pull entrance and target hoses over tubes of liquid of an automatic transmission so that end faces of hoses reached fillets on tubes.
4. Establish a hose clip on a hose in the center of marking and under the corner shown in drawing.
5. Check that the clip of a hose does not concern any other parts.
6. Establish the right mudguard of a motor compartment and fix seven screws.
7. Lower the car.
8. Check liquid level in an automatic transmission.