KIA RIO

since 2000 of release

Repair and car operation


Rio KIA
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, A5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
- 8. Transmission
   + 8.1. Mechanical transmission
   - 8.2. Automatic transmission of F4E-K
      8.2.1. Specifications
      8.2.2. Check of work and adjustment of position of the lever of the selector
      8.2.3. Testing of collaboration of an automatic transmission and the engine on the motionless car (stall test)
      8.2.4. Testing of a time lag (Lag test)
      8.2.5. Check of pressure of transmission liquid
      8.2.6. Check of level and liquid replacement in an automatic transmission
      8.2.7. Procedure of replacement of liquid in the converter of an automatic transmission
      8.2.8. Leakages of liquid from an automatic transmission
      8.2.9. Replacement of oil sealing rings
      8.2.10. Removal and installation of an automatic transmission
      8.2.11. Repair of an automatic transmission
      8.2.12. Radiator of cooling of liquid of an automatic transmission
      8.2.13. Block of valves
      8.2.14. The case of regulating valves
      8.2.15. Oil pump
      8.2.16. Check of resistance of the sensor of frequency of rotation of an entrance shaft \turbine wheel
      8.2.17. Check of resistance of the sensor of speed
      8.2.18. Switch of operating modes of a transmission of O\D
      8.2.19. Switch of a range of a transmission
      8.2.20. Sensor of temperature of an automatic transmission
      8.2.21. Electromagnetic valves
      8.2.22. Linear electromagnetic valve
      8.2.23. Selector lever
      8.2.24. Repair of the lever of the selector
      8.2.25. Check of functioning of the mechanism of blocking of the lever of the selector
+ 9. Axes and power shafts
+ 10. Suspension bracket
+ 11. Wheels and tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Air central air
+ 16. Electric equipment

8.2.18. Switch of operating modes of a transmission of O/D

Check

PERFORMANCE ORDER
1. Include ignition.
2. Be convinced that the O/D OFF indicator is not highlighted. Press the switch.
3. If the indicator does not work properly, continue check.

Tension check

PERFORMANCE ORDER
1. Remove the central console.
2. Include ignition.
3. Measure tension on contacts of the socket of the O/D switch.

Position of the switch
Socket contacts
Normal, In
1
4
Pressed, In
In +
0
In +: Tension of the storage battery
0
0
4. If tension on contacts of the socket of the switch differs from demanded, проворьте conductivity in the O/D switch

Conductivity check

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. Disconnect the socket from the O/D switch.
3. Check conductivity of the O/D switch on H-05 socket contacts.
Position of the switch
Socket contacts
1
4
The normal
are opened
The pressed
are closed
4. Otherwise replace the handle of the lever of the selector.
5. If the switch works normally, check the electric chain going to the control unit by a transmission.
6. Connect the O/D switch socket.
7. Establish the central console.
8. Connect a wire to the negative plug of the storage battery.